Description

Mounting Hardware is Included

This mount fits:

Savage 64 – Factory Drilled and Tapped Models

Savage 64 Takedown – Factory Drilled and Tapped (if mount is turned around)

Our Savage 64 mount is made specific to the gun. This mount can be used with the Savage 64 Takedown if it is turned around with the front overhang facing the rear.

This mount is only available in 0 MOA.

You must drill and tap your receiver for this mount to fit.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Rail Type:One Piece Picatinny

Machined from:Domestic 6061 T6 Extruded Aluminum

Finish:Matte Black Anodizing

Center Spread:3.345″

Overall Length:5.882″

Height:.4″ (Top of Receiver to Top of Picatinny)

Weight:2 oz.

Quick Disconnect Ring Compatible:No

Ambidextrous:Yes

Torque Specs:20 in/lbs

Mounting Hardware:#6-48 X 1/4 Screws and T-10 Bit Included